Frameless showers · Steam
Steam shower enclosures.
Floor-to-ceiling frameless glass enclosures built to hold steam, with an operable transom to vent and the seals a steam room needs.
Call or text (208) 286-1285 for a ballpark from a photo.
Marble steam enclosureGLASS23
What makes a steam enclosure different
A standard frameless shower is open at the top on purpose; it breathes. A steam shower is the opposite. The glass runs full height to the ceiling, every joint is sealed, and a transom panel above the door opens to vent the room when you are done. Get the geometry right and the room holds steam for as long as the generator runs. Get it wrong and the steam finds the gap.
What the room needs before the glass
Three things have to be true before we can build a steam enclosure. The ceiling inside the shower has to be flat and level where the glass lands, which usually means a sloped or flat tiled ceiling rather than drywall. The generator has to be sized to the room by whoever is installing it. And the layout has to be decided early in the remodel, because converting a standard enclosure to steam later almost always means new glass.
How we build it
Door and panels in 3/8 or 1/2 inch tempered glass, a hinged door with a drip rail and seals on every edge, and a transom panel hinged to open outward or on a pivot. Hardware in chrome, brushed nickel, matte black, satin brass or champagne bronze. We measure once the space is ready, send a written proposal with the configuration drawn, and install two to three weeks after approval.
Glass for a steam room
Clear and low-iron are both common. Low-iron Starphire is worth considering on a steam enclosure because there is more glass, more edge, and usually marble or large-format tile behind it that you chose for its color. Satin etch works where the shower faces the bedroom. Hard-water coatings matter more here than anywhere else in the house: a steam room wets every inch of the glass on every use.
Where we install steam showers
All three shops build steam enclosures: Boise for the Treasure Valley, Fremont for the Bay Area, Pacific Beach for San Diego. If you are planning a steam shower, text the shop nearest you a photo of the room early in the remodel. Five minutes on the layout then saves a reorder later.
Questions we get.
Does a steam shower need a transom?
Yes. The transom is how the room vents after use. Without it the enclosure stays wet and the room never dries out. Ours hinge open and close against a seal.
Can my existing shower become a steam shower?
Sometimes, if the ceiling is tiled and level and the room can take a generator. The existing glass usually cannot be reused, because a steam enclosure needs full-height panels cut to the ceiling.
What glass thickness does a steam enclosure use?
3/8 inch handles most steam enclosures. 1/2 inch comes in when panels are unusually tall or wide, or when the door is large and there is nothing to brace against.
How long does a steam enclosure take?
Two to three weeks from an approved proposal to install, the same as a standard enclosure. The measure happens once the space is ready.
Recent work.
Send a photo.
Get a number.
Text (208) 286-1285 a photo of the space with a rough width and height, or use the form. We come back with a ballpark, then measure and send a written proposal. We will beat a comparable quote more often than not; send it over and ask.